VOLTCRAFT B6 Notice D'emploi page 72

If the current value blinks, you can switch between manual and automatic mode by
simultaneously pressing the buttons "INC" and "DEC".

In manual mode, the accumulators are charged with the current you have set.
In automatic mode, the charger calculates the charge current automatically, all
you do is set the top limit for the charge current. Shorter charging times can be
achieved depending on the accumulator and its internal resistance.
• Change the charge current (or in automatic mode the top limit for the charge current) using
the buttons "INC" and "DEC", confirm the value using the "Start/Enter" button. The number
of cells is established automatically!
• To begin the charging process, keep the "Start/Enter" button pressed (approx. 3 seconds).
• If the charger detects an error (e.g. no accumulator connected), a warning signal is emitted
and a corresponding info appears on the display.
You can stop the audio signal by pressing the "Batt Type/Stop" button. You then return to
the previous configuration menu.
• If the accumulator is detected correctly. the following display appears, for example:
Accumulator type Charge current
NiMH 2.0A NiMH 2.0A NiMH 2.0A
NiMH 2.0A NiMH 2.0A
CHG 043:20 01253 CHG 043:20 01253
CHG 043:20 01253 CHG 043:20 01253 CHG 043:20 01253
Current charging duration
• Once the charging process has been completed, an audio signal is emitted.

If you wish to terminate the charging process beforehand, press the "Batt Type/
Stop" button.
72
Accumulator voltage
7.42V 7.42V 7.42V
7.42V 7.42V
Charge capacity in mAh