Warning Messages On The Display - VOLTCRAFT B6 Duo Notice D'emploi

19. WARNING MESSAGES ON THE DISPLAY

REVERSE POLARITY REVERSE POLARITY
REVERSE POLARITY REVERSE POLARITY REVERSE POLARITY
CONNECTION BREAK CONNECTION BREAK CONNECTION BREAK
CONNECTION BREAK CONNECTION BREAK
SHORT ERR SHORT ERR SHORT ERR
SHORT ERR SHORT ERR
INPUT VOL ERR INPUT VOL ERR
INPUT VOL ERR INPUT VOL ERR INPUT VOL ERR
VOL SELECT ERR VOL SELECT ERR
VOL SELECT ERR VOL SELECT ERR VOL SELECT ERR
BREAK DOWN BREAK DOWN
BREAK DOWN
BREAK DOWN BREAK DOWN
BATTERY CHECK BATTERY CHECK BATTERY CHECK
BATTERY CHECK BATTERY CHECK
LOW VOLTAGE LOW VOLTAGE
LOW VOLTAGE LOW VOLTAGE LOW VOLTAGE
BATTERY CHECK BATTERY CHECK BATTERY CHECK
BATTERY CHECK BATTERY CHECK
HIGH VOLTAGE HIGH VOLTAGE
HIGH VOLTAGE HIGH VOLTAGE HIGH VOLTAGE
BATTERY VOLTAGE BATTERY VOLTAGE
BATTERY VOLTAGE BATTERY VOLTAGE BATTERY VOLTAGE
CELL LOW VOL CELL LOW VOL CELL LOW VOL
CELL LOW VOL CELL LOW VOL
The polarity of the battery connections has been
switched.
The connection to the battery has been dis-
rupted, e.g. if the battery was disconnected
during the charging process.
A short-circuit has been identified on the
charger output.
The input voltage (operating voltage) for the
charger is too low.
The voltage of a LiPo, LiIon, LiFe battery to be
charged has been incorrectly configured.
The charger has identified an internal problem.
Should this message permanently be displayed,
it is possible that the charger is defective; have
it checked by a specialist workshop or qualified
technician.
During the charging process it was identified
that the battery is totally discharged.
In this case you should check if the voltage of
the battery has been correctly set for the charg-
ing process.
The voltage in one of the cells of a lithium
battery (LiPo, LiIon, LiFe) is too low. This can
occur if a multi-cell battery was previously
charged without a balancer.
99