VOLTCRAFT B6 Notice D'emploi page 88

BATTERY VOLTAGE BATTERY VOLTAGE BATTERY VOLTAGE
BATTERY VOLTAGE BATTERY VOLTAGE
CELL HIGH VOL CELL HIGH VOL
CELL HIGH VOL CELL HIGH VOL CELL HIGH VOL
BATTERY BATTERY
BATTERY BATTERY BATTERY
CELL CONNECT CELL CONNECT CELL CONNECT
CELL CONNECT CELL CONNECT
TEMP OVER ERR TEMP OVER ERR
TEMP OVER ERR TEMP OVER ERR TEMP OVER ERR
CONTROL FAILURE CONTROL FAILURE CONTROL FAILURE
CONTROL FAILURE CONTROL FAILURE
88
VOL ERR VOL ERR
VOL ERR VOL ERR VOL ERR
The voltage in one of the cells of a LiPo, LiIon, LiFe
accumulator is too high. This can occur if a multicell
accumulator has been charged previously without
a balancer.
The balancer cable was connected wrong or does
not fit to the pin assignment of the charger.
Excess temperature detected. Leave the charger
and the accumulator to cool down.
The charger has established that there is an internal
problem. Should this message permanently be
displayed, it is possible that the charger is defective;
have it checked by a specialist workshop or qualified
technician.