VOLTCRAFT B6 Notice D'emploi page 53

Masquer les pouces Voir aussi pour B6:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If this occurs, immediately disconnect the product from the power supply,
then disconnect the accumulator from the charger.
The exterior of the accumulator must be completely dried off and/or cleaned.
Do not use the charger again - bring it to a specialist workshop.
• The device is not a toy. It is not suitable for children. Pay particular attention
if children are present! Children could attempt to poke objects into the device.
This will result in the device being destroyed and there is a considerable risk
to life from electrical shock!
The product may only be set up, used or stored in places that are not
accessible to children. Children may change the settings or short-circuit the
accumulator/accumulator pack, which can lead to an explosion. Mortal
danger!
• Do not operate the appliance when it is unattended. Although there are a
wide range of comprehensive safety mechanisms on the device, it is
impossible to exclude the possibility of malfunctions or problems occurring
while charging a accumulator.
• Only use the device in a moderate climate, do not use it in a tropical climate.
For more information on acceptable environmental conditions, see the
chapter "Technical Data".
• Select a stable, level, sufficiently large and flat surface.
Never place the charger and accumulator on a flammable surface (e.g.
carpet). Always use a suitable, non-flammable, heatproof base.
• Ensure that there is sufficient ventilation during operation, never cover up the
charger and/or the connected accumulator. Leave enough distance (at least
20cm) between the charger, the accumulator and other objects.
• Never use the product immediately after it has been brought from a cold room
into a warm one. The resulting condensation may lead to malfunctions or
damage under certain circumstances!
Allow the charger (and the accumulator/batteries) to reach room temperature
before connecting the charger to the power supply and using it. This may take
several hours!
• Maintenance, setting jobs or repairs may only be carried out by a specialist/
specialised workshop. There are no components for you to adjust or maintain
within the device.
53

Publicité

Table des Matières
loading

Table des Matières