Error Messages On The Display - VOLTCRAFT V-CHARGE ECO 6X 1S Notice D'emploi

12. Error messages on the display

"E-1":
The input voltage is too low. The charging process is aborted and
a beep is emitted.
"E-2":
The input voltage is too high. Disconnect the charger from the
power supply immediately, otherwise damage is possible, this will
also void the warranty.
LED indicator flashes + no display
Disconnect the charger from the power supply; disconnect the con-
nected battery from the charger. Allow the charger to cool, then
resume operation. Check whether one of the batteries has deeply
discharged (or if the battery voltage is too high, e.g. if a LiPo bat-
tery has been accidentally charged as a LiHV battery).
Check the power supply. The charger requires an operating volt-
age of 9 - 15 V/DC; at full load on the charging channels and
the USB output, the charger consumes max. 45 W (approx.). If
a power adapter is used to operate the charger, it must have an
appropriate power level.
Never connect more than one battery to each charging channel.
Only charge 1-cell LiPo or LiHV batteries with the charger.
58