VOLTCRAFT B6 Notice D'emploi page 79

• Briefly press the button "Start/Enter"; the current value in the bottom line starts to blink.

With NiCd or NiMH accumulators, you can switch between manual and
automatic mode by simultaneously pressing the buttons "INC" and "DEC" (see
chapter 12. a).
With lithium accumulators, the cell number must also be set besides the charge
current.
Change this as usual using the buttons "INC" and "DEC", confirm the value using the "Start/
Enter" button.
• If the values do not blink, you can select between the individual programs with the buttons
"INC" or "DEC". Depending on the accumulator type, these are "CHARGE", "DISCHARGE",
"STORAGE", "BALANCE", "CYCLE", etc.
• If you now keep the button "Start/Enter" depressed for approx. 3 seconds, all settings are
saved in the memory selected at the beginning.

Of course, the data in the 5 memory slots is preserved, even if the charger is
separated from the supply voltage.
This way, you can save the data for the transmitter accumulator, for example
(e.g. NiMH, charge current 400mA) and for a flight accumulator (LiPo, 1A
charge current, 3 cells).
79