Discharging Accumulators ("Discharge") - VOLTCRAFT B6 Notice D'emploi

c) Discharging accumulators ("DISCHARGE")
• After you have selected the "Pb" program in the main menu with the button "Batt Type/Stop"
and confirmed this with the button "Start/Enter", you can select the discharge function using
the button "INC" or "DEC":
Pb DISCHARGE Pb DISCHARGE
Pb DISCHARGE
Pb DISCHARGE Pb DISCHARGE
0.1A 0.1A
0.1A 0.1A 0.1A
The value on the left in the second line shows the discharge current, the value on the right
shows the voltage or number of cells of the accumulator (in this example, a 6-cell lead
accumulator, 6x 2.0V = 12.0V).
• If the values need to be changed, press the "Start/Enter" button. The discharge current
blinks. Change the discharge current using the buttons "INC" and "DEC", confirm the value
using the "Start/Enter" button.
• The voltage/cell number then begins to flash. Change it using the buttons "INC" and "DEC".
You should be aware while doing this that the voltage only changes with the number of cells
(e.g. one cell = 2.0V, two cells 4.0V etc.) Confirm the setting by pressing the "Start/Enter"
button.

The charger sets the final discharge voltage automatically for safety reasons.
• To begin the discharge process, keep the "Start/Enter" button pressed (approx. 3 seconds).
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and
the appropriate information is shown on the display.
You can stop the audio signal by pressing the "Batt Type/Stop" button. You then return to
the previous configuration menu.
• If you press the button "Start/Enter" during the discharge process, the discharge current can
be changed (see above).
• Once the discharge process has been completed, an audio signal is emitted.

If you wish to terminate the discharge process beforehand, press the "Batt
Type/Stop" button.
12.0V(6P) 12.0V(6P)
12.0V(6P) 12.0V(6P) 12.0V(6P)
77