Left And Right Side Balance For Buttonhole; Zippers And Piping - JUKI HZL-353Z Série Manuel D'instructions

0 1~4
56
Left and right side
balance for buttonhole
Stitch density on right and left
sides of buttonhole can be
adjusted by button-hole
balance control dial.
This dial should usually be in a
neutral position. (between "+"
and " ")
If the stitches on the left side of
the buttonhole are too close
together, turn the dial to the left
(+).
* Turning dial to the left opens
left side.
If the stitches on the left side of
the buttonhole are too open,
turn the dial to the right ( ).
* Turning dial to the right closes
left side.

Zippers and piping

The zip foot can be inserted
right or left, depending on
which side of the foot you are
going to sew. (1)
To sew past the zip pull, lower
the needle into the fabric, raise
the presser foot and push the
zip pull behind the presser foot.
Lower the foot and continue to
sew.
It is also possible to sew in a
length of cord, into a bias strip
to form a 'welt'.
Set stitch length control
between "1" - "4" (according to
thickness of fabric). (2)