Monogramming And Embroidering With Embroidery Hoop - JUKI HZL-353Z Série Manuel D'instructions

1~5 0
a a
b b
a
b
70
Monogramming and
embroidering with
embroidery hoop*
Drop the feed dogs. (1)
- Remove the presser foot and
the presser foot holder.
- Lower presser foot lever
before starting to sew.
- Adjust the stitch width
according to the size of
lettering or design.
Preparation for
Monogramming and
Embroidering*
- Draw the desired lettering or
design on the right side of the
fabric.
- Stretch the fabric between
embroidery hoop as firmly as
possible.
- Place the fabric under the
needle.
Make sure the presser foot
bar is down in its lowest
position.
- Turn the balance wheel
towards you to bring up the
lower thread through the
fabric. Sew a few securing
stitches at the starting point.
- Hold the hoop with thumb and
forefingers of both hands
while pressing the material
with the middle and third
fingers and supporting the
outside of hoop with smaller
finger.
* Embroidery hoop not included
with machine.