Earthing; Closing The Housing; Fan Version - Videotec Medusa Manuel D'instructions

Masquer les pouces Voir aussi pour Medusa:

Table des Matières

Les langues disponibles

6.3.2 Earthing

If the input voltage is 230Vac, earth the housing

applying the two supplied cables to the cover and

body using M3*6T screws and the toothed washers.

Complete the cabling inserting the fastons into the

corresponding seats on the HEATER auxiliary board.

Fig. 19

Disseccant

salt sachet

Fig. 20

Take the dessicant salt sachet out of its transparent

pack and insert it into the pocket shown in figure.

Close the housing by positioning the cover correctly

and fastening the top down using the four screws

Only now is it possible

to power the housing

The fan version of the housing has two side

filters on the aluminium body, protected by the

cover, while two additional fans are installed

in the adapter ring, to circulate air from the

inside to the outside of the housing.

Fig. 21

Fig. 22

This makes it possible to lower the temperature

difference between inside and outside when

the housing is used at high temperatures.

Using this application means the

housing will lose its IP66 rating.

Table des Matières

Table des Matières