How To Install The Camera; 12Vdc/24Vac Version; 120/230Vac Version; Closing The Housing - Videotec NXM36 Manuel D'instructions

6.2 How to install the camera

Open the housing as described (6.1 How to open the
housing, page 4).
Fit the camera on the slide, using the insulating plate
and the supplied 1/4" screw. If necessary, use the
spacers to position the camera and optics correctly.
Fig. 3
Feed the cables through the cable grip, and make the
necessary electrical connections, ensuring that the
cable grips are holding firmly.

6.2.1 12Vdc/24Vac version

When the power supply voltage is 24Vac the circuit
will be connected by the terminals shown.
IN 12Vdc/24Vac
OUT 12Vdc/24Vac
Fig. 4
MNVCNXM36_1511_EN
Heater OUT 12Vdc/24Vac

6.2.2 120/230Vac version

IN 115/230Vac
OUT 115/230Vac
Fig. 5

6.3 Closing the housing

Before closing the housing reinsert the bottom
orientating the slide according to the installation
required, on the wall bracket or on the Pan & tilt
head, for the right camera fitting (6.1 Installing the
housing, page 6).
Close the housing taking care not to damage the
sealing ring. Make sure that the sealing ring is
correctly fitted in its position.
Pay attention to the fixing. Tightening
torque: 4Nm.
Heater OUT 115/230Vac
5