Maintenance And Cleaning; Working Safely - HBM QuantumX Manuel D'emploi

ITC-K1000
S The ITC-K1000 is intended solely for use in combina­
tion with a QuantumX MX809B. If the ITC-K1000 is
also integrated into a system, it is the responsibility of
the system installer to keep the system safe.
1.3

Maintenance and cleaning

Please note the following points when cleaning the
ITC-K1000:
S Disconnect the ITC-K1000 from all current and
voltage supplies.
S Take suitable measures to ensure that the ITC-K1000
cannot be exposed to dangerous electric potential.
S Clean the parts of the ITC-K1000 with a soft, slightly
damp (not wet!) cloth. You should never use solvents,
since they could damage the parts of the
thermocouple.
S When cleaning, ensure that no liquid gets into the
parts of the ITC-K1000 connector.
S Give the ITC-K1000 sufficient time to dry before
starting it up again.
1.4

Working safely

S When unpacking the contents of the package, check
to ensure that everything is present. When it is un­
packed, the ITC-K1000 should be inspected for
mechanical damage. If damage has occurred during
transit, the thermocouple must not be operated.
S Error messages should only be acknowledged once
the cause of the error has been eradicated and there
is no further danger.
A4749-1.0 HBM: public
Safety instructions
5