Scope Of Supply; Area And Method Of Use - HBM C6A Notice De Montage

C6A
1

Scope of supply

• 1 C6A force transducer
• 1 C6A Operating Manual
Accessories (not included in the scope of supply):
• load button:
• spherical cap:
• pendle bearing - top:
2

Area and method of use

The transducers are designed for the measurement of static and dynamic
pressure forces.
Tensile forces can also be measured with the transducers. The tension
elements required for this are attached to the top face of the transducer and
fed through the inner bore of the transducer so that tensile forces initiated via
the tension anchor act as pressure forces. The transducers can be installed in
any position for force measurement. The force conductor must however act in
the direction of the transducer axis.
HBM force transducers in this range measure dynamic forces in the load
direction just as precisely as static forces. In so doing the sum of the dynamic
loading and the static starting load must not exceed the nominal load.
The force transducers are maintenance − free and can be installed even in
poorly accessible places. Their electrical measurement signals can be
transmitted to remote measuring points and monitors in order to indicate and
register there and be used for control and regulating tasks.
As precision measuring instruments the force transducers must be handled
carefully during transport and mounting; impacts or dropping the transducer
could result in permanent damage. Loading impacts (e.g. applying a load in
"freefall") in measuring mode can also result in unexpected overload with
lasting damage. Where such loading impacts cannot be ruled out they must
be checked.
The limits for the permissible mechanical stresses are stated in the
Specifications.
A0638−2.3 en/de/fr
1−C6A/20T/ZL; 1−C6A/50T/ZL; 1−C6A/100T/ZL;
1−C6A/200T/ZL; 1−C6A/500T/ZL
1−C6A/50T/ZK; 1−C6A/100T/ZK; 1−C6A/200T/ZK;
1−C6A/500T/ZK
1−EPO3R/20T; 1−EPO3/50T; 1−EPO3/100T;
1−EPO3/250T; 1−EPO3/500T
7
HBM