Parts Replacement; Replacement Of The Burner Nozzle - Angelo Po FX61 G3 Manuel D'installation Et D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section 7

Parts Replacement

REPLACING PARTS RECOMMENDATIONS
IMPORTANT _________________________
Before
carrying
out
procedure, activate all safety devices
provided and decide whether staff at
work and those in the vicinity should be
informed. In particular, turn off gas and
water supply valves, cut off the electricity
supply to the appliance using the master
switch and prevent access to all devices
which might cause unexpected health and
safety hazards if turned on. If worn parts
have to be replaced, use original spare
parts only.
The manufacturer declines all responsibly
for
injury
or
damage
due to the use of non-original parts, or
extraordinary
work
which may modify the safety requirements
without the manufacturer's authorization.
When ordering components, follow the
instructions provided in the parts catalog.
Before performing any service
WARNING
that
involves
electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
Replacement operations must
WARNING
be performed by an authorized service
agent in accordance with all relevant local
and legal requirements.
87 Combination Oven Installation and Operation Manual
PARTS REPLACEMENT
any
replacement
to
components
on
the
appliance
connection
or
REPLACEMENT OF THE BURNER
NOZZLE
To carry out this operation, proceed as follows:
1. Undo screws to remove side panel (A).
2. Disconnect gas supply line (B).
A
B
3. Remove injector (C) and replace it with one suitable
for the type of gas in use (see table below).
Burner nozzle (mm/100)
Gas type
FX61
FX101
Ø 635
Ø 605
Natural
gas
Ø 465
Ø 485
Propane
IMPORTANT _________________________
Take care to ensure that nozzle (C) is
correctly positioned (see diagram).
4. Reconnect pipe (B), replace panel (A) and
retighten screws when the operation is complete.
IMPORTANT _________________________
When the operation is complete light the
burner and check through the fl ame viewer
that the burner is operating correctly.
C
C
FX82
FX122
FX201
FX202
Ø 635
Ø 615
Ø 640
Ø 615
Ø 485
Ø 500
Ø 465
Ø 480

Publicité

Chapitres

Table des Matières
loading

Table des Matières