Replacing The Fuse; Changing The Lamp - Angelo Po FX61 G3 Manuel D'installation Et D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section 7
Parts Replacement

REPLACING THE FUSE

WARNING Before performing any service
that
involves
electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
To perform this operation, proceed as follows.
WARNING Disconnect the power supply
before replacing fuses.
1. Undo screws and remove side panel (A).
2. Open fuse-holder (B) and replace damaged fuse (C).
3. Replace fuse-holder and side panel when the
operation is complete.
C
B
88 Combination Oven Installation and Operation Manual
connection
A

CHANGING THE LAMP

WARNING Before performing any service
or
that
involves
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
To perform this operation, proceed as follows.
WARNING Disconnect the power supply
before replacing lamps.
1. Undo screws and remove lamp cover (A).
2. Remove and replace lamp (B).
A
WARNING During the procedure, take
care not to touch the lamp directly; wear
protective gloves if necessary.
3. Replace lamp cover (A) and retighten screws
when the operation is complete.
Note: the appliance wiring diagram location can be
found on the "Safety Lable and Sign Location" page.
electrical
connection
B
or

Publicité

Chapitres

Table des Matières
loading

Table des Matières