Decommissioning The Appliance - Angelo Po FX61 G3 Manuel D'installation Et D'opération

CHANGING THE IGNITION PLUG
WARNING Before performing any service
that involves electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
To carry out this operation, proceed as follows:
WARNING Disconnect the power supply
before changing ignition plug.
1. Undo screws and remove side panel (A).
2. Open the tangs (B) and remove the guard (C).
3. Undo the nuts (D) to remove the ignition plug
unit (E).
4. Replace the guard and close the tangs when
done.
A
C
connection
B
D
E
D

DECOMMISSIONING THE APPLIANCE

WARNING Before performing any service
or that involves
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
When decommissioning the appliance, a series
of procedures must be carried out to ensure the
appliance and its components are no longer an
obstacle and are not easily accessible.
To ensure the appliance does not present a hazard
for people or the environment, all energy sources
(electricity, etc.) must be disconnected and made
unusable, and any liquids present must be drained
(lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not
easily accessible with barriers to prevent anyone
from accessing it.
When scrapping, sort all components by material
type and dispose of them separately in accordance
with the relevant local recycling requirements and
regulations.
IMPORTANT _________________________
Do not dump
products, lubricating
metallic components
resins, etc.) in the environment. Dispose
of them in compliance with all relevant
laws, regulations,
requirements.
Combination Oven Installation and Operation Manual
Section 7
Parts Replacement
electrical connection
non-biodegradable
oils, and
(rubber,
and local recycling
or
non-
PVC,
89