Angelo Po FX61 G3 Manuel D'installation Et D'opération page 24

Section 4
Handling and Installation
GAS SUPPLY CONVERSION
Before proceeding with the
WARNING
conversion, shut off gas supply before
disconnecting the electrical power.
WARNING Before performing any service
that involves electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
The manufacturer has tested the appliance with its
own mains gas, identifi ed by the sticker applied to
the nameplate.
If the type of gas to be connected is different from
that used for testing, proceed as follows.
1. Turn off gas supply valve (A).
2. Change the burner nozzle (see page 87).
3. Remove the testing gas sticker from the data
plate (B) and apply the new one to identify the
gas being used.
4. Access the "Service" menu and activate the
"Gas type conversion" procedure (see page 29).
5. Carry out the appliance testing procedure (see
page 25).
24 Combination Oven Installation and Operation Manual
connection or
B
IMPORTANT _________________________
Upon completing the operation, make sure
there are no gas leaks or malfunctions.
Do not use an open fl ame to
WARNING
test for gas leaks. Use a commercial leak
detector or a soap and water solution.
The gas supply conversion
WARNING
must be made by an authorized service agent
in accordance with the manufacturer's
specifi cations and all applicable codes
and requirements of the authority having
jurisdiction. If the procedures in these
instructions are not followed exactly, a
fi re, an explosion or production of carbon
monoxide may result causing property
damage, personal injury or death. An
authorized service agent is responsible
for proper conversion. Installation is not
proper and complete until the operation
of the converted appliance is checked as
specifi ed in the manufacturer's instructions
supplied with the kit.
A