SAFETY LABELS AND SIGNS
A 1 Water specications (Hardness, pH, Conductivity)
2 Equipotential terminal
3 Read the manual
4 This equipment is to be installed to comply
with the applicable Federal, state, or local
plumbing codes having jurisdiction.
5 DANGEROUS VOLTAGE
B WATER DRAIN
C Wiring diagram
D Leave the door ajar once the cooking cycle and
cleaning operations have terminated
E
Caution: hot surfaces
F
Caution: very hot steam
G Warning: Improper installation, adjustment
alteration, service or maintenance can cause
property damage, injury or death. Read
the installation operating and maintenance
instructions thoroughly before installing or
servicing the equipment; This appliance is for
use only with the specifi c legs or base provided;
Intended for other than household use.
CLEARANCE: BACK / 0 inches / LEFT SIDE
19.7" inches (500 mm) - RIGHT SIDE 7.8"
inches (100 mm); All clearance are the same
for combustible and non-combustible location;
Suitable for installation on combustible fl oors;.
CAUTION:
DISCONNECT
SUPPLY BEFORE SERVICING. Cooking chamber
convection fan can rotate in a clockwise and anti-
clockwise direction.
H) WARNING: This appliance is for use only with
the specifi c fl ue chimney provided; For installation
under ventilation hood only; This appliance can
be used with propane gas and natural gas. It is
shipped from the factory adjusted for use with
natural gas; Not suitable for connection to type
B gas vent; For your safety refer to installation
instructions for conversion procedure.
L) CAUTION: To reduce the risk of electric
shock, do not remove or open cover. No user-
serviceable parts inside. Refer servicing to
qualifi ed personnel.
Use supply wires suitable for 75°C (167°F).
Use copper wire only for power-supply connections
M) NAME PLATE
N) WARNING: Type and rating of fuse
O) NOTICE: When this appliance is installed with
casters, it must be installed with the casters
supplied, a connector complying with either
ANSI Z21.69 • CSA 6.16 and a quick-disconnect
device complying with ANSI Z21.41 • CSA
6.9. It must also be installed with restraining
means to guard against transmission of strain
to the connector, as specifi ed in the appliance
manufacturer's instructions.
P) SWITCHING THE APPLIANCE ON AND OFF
THE
POWER
Combination Oven Installation and Operation Manual
Section 1
Safety Precautions
9