Angelo Po FX61 G3 Manuel D'installation Et D'opération page 92

Section 8
Troubleshooting
KEY TO ALARM TABLE
Alarm Fault
No water in chamber, or
H2O
water pressure too low
No water at drain, or water
H2O.
pressure too low
No mains gas, gas
E12
pressure too low or fl ame
detection failure
Oven door opening or
OPE
closure request
Indicates that cleaning is
CLE
required
Indicates the need for the
dEC
descaling operation
The cooking chamber
E01
probe has failed or is not
properly connected
The core probe has a
E02
failure or has not been
properly connected
The steam discharge probe
E03
has failed
The motor-operated valve
E04
is not positioned correctly
Safety thermostat failure
E05
Overload cutouts tripped
E06
Power board failure
E07
The optional vacuum probe
E08
has failed or is not properly
connected
92 Combination Oven Installation and Operation Manual
Remedy
Check that mains water is pres-
ent or adjust the pressure (see
page 25); if the problem persists
call an authorized service agent
Check that water supply is
present or adjust the pressure
(see page 25); if the problem
persists call an authorized
service agent
Press reset button (the button
may have to be pressed several
times); if the problem persists
call an authorized service agent
Open or close the oven door,
Call an authorized service
agent if this message continues
to be displayed
Launch an automatic cleaning
cycle
Perform descaling
Call an authorized service
agent
Check the position of the prod-
uct core probe or call an autho-
rized service agent if it is faulty
Call an authorized service
agent
Switch on the oven again and
if the problem persists call an
authorized service agent
Call an authorized service
agent
Call an authorized service
agent
Call an authorized service
agent
Press the "Reset" button
Notes
Convection cooking cycles can still
be performed
Convection and steam cooking
cycles can still be performed
Stop cooking if this message is
repeated more than once
The cooking cycle does not start
until the door has been opened or
closed as required
The oven's functions are enabled;
cooking cycles can be performed
The oven's functions are enabled
so cooking cycles can be carried
out
The oven's functions are disabled;
no cooking cycles can be
performed
Cooking cycles with product core
probe cannot be performed
Convection and steam cooking
cycles can still be performed
Convection and steam cooking
cycles can still be performed
The oven's functions are disabled;
no cooking cycles can be
performed
The oven's functions are disabled;
no cooking cycles can be
performed
The oven's functions are disabled;
no cooking cycles can be
performed
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle. If the problem
persists, call an authorized service
agent