Technical Characteristics Of The Product - Nice Naked Sliding Instructions Et Avertissements Pour L'installation Et L'utilisation

WARNINGS: • All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C). • Nice S.p.a. reserves the right to apply modifi-
cations to products at any time when deemed necessary, maintaining the same intended use and functionality.
Technical characteristics NKSL400
Type
Pinion
Peak thrust
[corresponding to the ability to
develope a force capable of moving
the leaf]
Nominal torque [corresponding to the
ability to develope a force capable of
maintaining the movement of the leaf]
Nominal torque speed
Idling speed (the control unit allows
6 speeds to be programmed,
approx. equal to: 100, 85, 70, 55, 45,
30%) 70, 55, 45, 30%)
Maximum frequency of operating
cycles (nominal torque)
Maximum continuous operating
time (nominal torque)
Operating limits
Durability
NAKED power supply
Thrust maximum absorbed power
[equivalent to amperes]
Insulation class
Emergency power supply
Flashing light output
Open Gate Indicator Output
BLUEBUS output
STOP input
Step-by-step Input
OPEN input
CLOSE input
Radio connector
Radio AERIAL Input
Programmable functions
Self-Recognition functions
Operating temperature
Use in acid, saline or potentially
explosive atmosphere
Protection class
Dimensions and weight

TECHNICAL CHARACTERISTICS OF THE PRODUCT

Electromechanical gearmotor for the automatic movement of sliding gates for residential use, complete with elec-
tronic control unit
Z: 15; Modulo: 4; Passo: 12,6 mm; Diametro primitivo: 60mm
12Nm; corrispondente alla capacità di mettere in movimento un'anta con attrito dinamico fino a 400N
6Nm; corrispondente alla capacità di mantenere in movimento un'anta con attrito dinamico fino a 200N
0.18m/s
0.34m/s
35 cycles / day (the control unit allows up to the maximum described in tables 2 and 3)
10 minuti
In general, NAKED is suitable for the automation of gates featuring weights or lengths as shown in Tables 1, 2
Estimated between 20.000 cycles and 180.000 cycles, depending on the conditions reported in Table 3
230Vac (+10% -15%) 50/60Hz.
330W
1 (a safety grounding system is required)
With PS124 optional accessory
For 2 LUCYB flashing lights (12V, 21 W lamp)
For one 24V maximum 4W bulb (the output voltage may vary between –30 and +50% and can also control small
relays)
One output with a maximum load of 15 BlueBus units
For normally open contacts, for 8,2KΩ; constant resistance, or normally closed contacts; with self-recognition
(any variation from the memorized status causes the "STOP" command)
For normally open contacts (the closing of the contact causes the "STEP-BY-STEP" command)
For normally open contacts (the closing of the contact causes the "OPEN" command)
For normally open contacts (the closing of the contact causes the "CLOSE" command)
"SM" connector for SMXI and SMXIS receivers
52Ω for RG58 or similar type of cable
8 ON-OFF functions and 8 adjustable functions (see tables 7 and 9)
Automatic identification of devices connected with the BlueBus outlet
Self-recognition of the type of "STOP" device (Normally Open, Normally Closed contact or 8,2KΩ)
Self-recognition of the gate length and calculation of the deceleration points and the partial opening point.
-20°C ÷ 50°C
No
IP 44 on the finished product if installed according to proper installation criteria
131x135xh405; 6.5 kg
English – 17