Disposal Of The Product; Technical Specifications; Simplified Eu Declaration Of Conformity - Nice E QUICK M 817 SH Instructions Et Avertissements Pour L'installation Et L'utilisation

What to do if...
(troubleshooting guide)
• The motor does not start if the power is turned on to one phase (Raise or
Lower).
a) Check whether the motor thermal has been tripped. If this is the case, wait until
the motor cools to restore normal functioning.
b) Check that the power is on and the grid voltage corresponds to the values appear-
ing on the motor plate.
c) Check whether the motor has been shut down by the limit switch in either direction
of rotation. If this is the case, adjust the limit switch levels again using the proce-
dure described in chapter 5.
d) Check that the control pushbutton strip has been connected up correctly (refer to
fig. 7).
e) Check that the power cable is in good condition.
• If the motor does not stop automatically when it reaches a limit switch.
a) Make sure that the two "arrow" buttons on the motor head are in the lowered
position, that is, flush with the motor surface.
b) While the manoeuvre is underway, make sure that the winding roller drives the limit
switch ring nut (fig. 8-h).
• If the programmed limit switch settings move the first time you use the
device.
a) Repeat the procedure described in chapter 5 to compensate the play between the
mechanisms.
If problems persist after these checks contact a qualified technician or the Nice Ser-
vice Centre.

Disposal of the product

This product is an integral part of the automation and therefore must be disposed together
with the latter.
As in installation operations, disposal operations must be performed by qualified
personnel at the end of the product's lifespan.
The product is made of various types of materials: some of them may be recycled,
while others must be scrapped. Find out about recycling and disposal systems in
use in your area for this product category. Warning! – Some parts of the product
may contain polluting or hazardous substances which, if released to the environ-
ment, may cause serious damage to the environment or to human health. As indi-
cated by the symbol appearing here, the product may not be disposed
of with other household wastes. Separate the waste into categories for
disposal, according to the methods established by current legislation in
your area, or return the product to the retailer when purchasing a new
version. Warning! – Local legislation may impose heavy fines in the event
of illegal disposal of this product.
The product's packaging materials must be disposed of in full compliance with local
regulations.

Technical specifications

Refer to the technical characteristics stated on the motor's nameplate.
Note: • All technical specifications stated herein refer to an ambient temperature of
20° C (± 5° C). • Nice S.p.A. reserves the right to apply modifications to products
at any time when deemed necessary, maintaining the same intended use and func-
tionality.

Simplified EU declaration of conformity

Hereby, NICE S.p.A., declares that the radio equipment type E QUICK M 817 SH, E
QUICK M 1517 SH, E QUICK M 3017 SH, is in compliance with Directive 2014/53/
EU.
The full text of the EU declaration of conformity is available at the following internet
address: https://www.niceforyou.com/en/support.
COMPLIANCE WITH THE FCC RULES (PART 15) AND RSS-210 RULES
This device complies with Industry Canada's licence-exempt RSS-210s, and with
Part 15 of the FCC rules of the United States of America. Operation is subject to the
following two conditions: (1) this device may not cause interference; (2) this device
must accept any interference, including interference that may cause undesired op-
eration of the device. Any changes or modifications made to this device, without the
express permission of the manufacturer, may void the user's authority to operate
this device.
3 – English