Control Of The Number Of Manoeuvres Performed; Manoeuvre Counter Reset - Nice Naked Sliding Instructions Et Avertissements Pour L'installation Et L'utilisation

8.2.4 - Control of the number of manoeuvres performed

The number of manoeuvres performed as a percentage on the set limit can be
verified by means of the "Maintenance warning" function. Follow the indications
in table 14 for this control.
01. Press the key "Set" and hold it down (approx. 3 s);
02. Release the key "Set" key when L1 LED starts flashing;
▲ ▼
03. Press key " " or " " to move the flashing LED onto the input LED representing the "Maintenance warning" parameter;
04. Press the key "Set", and hold it down during step 5, 6 and 7;
05. Wait approx. 3 seconds, after which the LED representing the current level of the parameter "Maintenance warning" will light up;
06. Press and immediately release the "
07. The LED that corresponds to the selected level flashes. The number of flashes indicates the percentage
of manoeuvres performed(in multiples of 10%) in relation to the set limit.
For example: with the maintenance warning set on L6 being 10000, 10% is equal to 1000 manoeuvres;
if the LED flashes 4 times, this means that 40% of the manoeuvres have been reached (being between
4000 and 4999 manoeuvres). The LED will not flash if 10% of the manoeuvres hasn't been reached.
08. Release the key "Set".

8.2.5 - Manoeuvre counter reset

After the maintenance of the system has been performed the manoeuvre
counter must be reset.
Proceed as described in table 15.
01. Press the key "Set" and hold it down (approx. 3 s);
02. Release the key "Set" key when L1 LED starts flashing;
▲ ▼
03. Press key " " or " " to move the flashing LED onto the input LED representing the
"Maintenance warning" parameter;
04. Press the key "Set", and hold it down during step 5 and 6;
05. Wait approx. 3 seconds, after which the LED representing the current level of the parameter "Maintenance warning" will light up;
06. Press keys "▲" and "▼", hold them down for at least 5 seconds and then release them.
The LED that corresponds to the selected level flashes rapidly indicating that the; manoeuvre counter has been reset
07. Release the key "Set".
TABLE 14 - Control of the number of manoeuvres performed
▲ ▼
" and " " keys;
TABLE 15 - Manoeuvre counter reset
SET 3s
or L7
SET
3s
and
.... n=?
SET
SET
3s
L1
SET
or
L7
SET
3s
and
SET
English – 13