Puky Kinderfahrrad Mode D'emploi page 12

Children's bike
4. Unpacking and scope of delivery
Do not use any sharp objects when opening
the packaging and removing protective materi­
al. If you were to do so, you may damage the
paint or parts of the bike.
Keep all packaging material out of reach of
children.
• Remove all parts from the packaging.
• Remove the protective material.
• Examine the package for completeness and
proper condition. If anything is missing,
please contact your dealer before you con­
tinue to assemble the bike.
The delivery consists of (Figure A):
1. Bike preassembled
2. Handlebar preassembled
3. Pedals and User Manual in a plastic bag, for
3­gear models: Additional gear stick
5. Assembly and first use
Prepare for use by adjusting to the height of the
child. The saddle is to be set so that at least the
toes, preferably the ball of the foot, reach the
ground in order to ensure balance can be
achieved when at a standstill. In doing so, the
marking showing the minimum insertion depth
on the saddle post into the frame tube must be
observed. For more information, see below.
The handlebar, hand brake lever and bell must
be easy for the child to reach from the set sad­
dle position.
In doing so, the marking showing the minimum
insertion depth of the handlebar shaft must be
observed. After adjusting the handlebar, tighten
the clamping screws firmly. Use the following
safety checklist to check the bicycle before
using.
When mounting the pedals, observe the right
and left threads (labelled on the pedal axis with
an R or L in the vicinity of the thread).
The images for the assembly instructions can
be found on the last pages of this manual.
After assembly, please conduct a safety check
in accordance with the safety checklist!
During assembly, please note that some parts,
such as pedal thread and clamping cone are
lubricated.
You will need the following tools for
assembly (Figure B):
1. 6 mm Allen key (ZL models) or a 13 mm
spanner (Z models)
2. 5 mm Allen key (only for ZL 18­3 models)
3. 15 mm spanner
4. Crosstip screwdriver
The tools are not part of the scope of delivery.
Assembly must be carried out with great cau­
tion and by an adult, to avoid any potential sub­
sequent accidents or injuries. Please take your
time when assembling the bike. In some cases,
it is necessary to tighten screws with a pre­
scribed torque. The torque value is stated in
Newton metres (e.g. 2 Nm). If the torque with
which a screw is tightened is too low, the con­
nection may still be too loose and therefore
unsafe. If the torque is too high, screws and
other parts may be damaged or destroyed.
Please contact your dealer or a workshop if you
have any questions.
First remove the plastic protective caps from
the cap nuts of the front and rear axle as well
as from the cantilever brakes at the front. Also
remove the plastic foil which has been used to
protect the cranks.
12