Front Axle Measurement And Adjustment Window - SICE A98 Manuel D'instructions

The icons assume the following forms:
- Large icon with pointer.
Provides an approximate indication of the status of the angle and the wheel position (shown on
an arc with different coloured zones: red zones mean value outside tolerance range, central
green zone mean acceptable value);
The large icon with pointer ceases to be animated and the coloured arc disappears when
there are no tolerance values for the vehicle selected.
- Small icon with coloured scale.
Provides a high-precision reading, appropriate to the tolerance value, of the variations in
the adjustment value in relation to the tolerance value. Displayed instead of the large icon
with pointer when this icon gives a reading in the green zone. The reading is provided on a
graduated bar. When the wheel value is near the limits of the tolerance range, the bar
background is white. It switches to green when the wheel adjustment value is at +/- 4
grades from the nominal setting value.
• At the bottom of the window, over the F5 and F6 keys, there is the status of the levelling
gauges of the targets applied on the axle being measured.

FRONT AXLE MEASUREMENT AND ADJUSTMENT WINDOW

Displays the measured values for the vehicle front axle and the adjustment reference
tolerances.
The values are continually updated to guide the operator performing the adjustment.
The following keys are active in this window:
- F1 displays the on-line "Help"
- F2 goes back to the previous window
- F3 (or Enter): advances to the next window
- F4 sets:
 Unit of measurement
Toe angle

o Degrees
o Length
Setback and Track Difference

o Degrees
o Length
Length

o Millimetres
o Inches
Angles

o Centesimal degrees
o Sexagesimal degrees
Pressure

o Bar
o Psi
Weight

o Kilograms
o Pounds
Mileage/Kilometres on the clock

o Kilometres
o Miles
35