Job Record Management Window; Vehicle Record Window - SICE A98 Manuel D'instructions

Mileage/Kilometres on the clock

• Kilometres
• Miles
 Job record
Type

• Minimal
• Complete
- F5 to access job record management
- F6 to access vehicle record management
- F7 to access customer record management
- F8 to access operator record management
- F9 to access the databank and select the vehicle make/model (the databank can also be
accessed by pressing the down arrow on the "Make" line)
- F10 aborts the job in progress and returns to the starting window.
Notes
• By entering the customer and vehicle data, the program checks if the same data are already
stored in the file. If the data are already stored, the page is automatically filled in with the
previously stored data. If all of or some data are not present, they will be stored upon job
completion only.
Note: Data storage is performed only if set in the wheel aligner general set-up.
To access this window, press the F5 key from the job record input window.
It displays the list of jobs saved on file. To make the selection, proceed as described in the
"General considerations" section.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter"): confirms selection of a job and advances to the window which displays the
job record on file.
- F4 orders the job record list according to:
• Date;
• Customer;
• Vehicle registration number:
• Operator;
• Order number
- F5 complete list of the jobs in the file.
- F7 deletes the job record selected from file
- F10 returns to the job record input window.
To access this window, press the F6 key from the job record input window.
It displays the list of vehicles saved on file.
To make the selection, proceed as described in the "General considerations" section.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 returns to the previous window

JOB RECORD MANAGEMENT WINDOW

VEHICLE RECORD WINDOW

25