SICE A98 Manuel D'instructions page 77

- F8 displays a window with a list of working windows. Used for skipping quickly between
windows.
- F10 returns to the starting screen.
To perform the standard steering procedure, follow the on-screen instructions and proceed as
described below:
• release the turntables;
• align the wheels by following the on-screen indicator until "STOP" is displayed;
• lock all the targets, perfectly level
• turn the wheels 10° or 20° to the left until the "STOP" message is displayed;
• wait for the data acquisition and for the turn-right arrows to appear;
• turn the wheels 10° or 20° to the right (relative to the centre position) until the "STOP"
message is displayed;
• wait for the data acquisition and for turn-left arrows to appear;
• turn the wheels back to the left to straighten the steering.
If the full steering procedure has been selected, proceed as follows:
• release the turntables;
• align the wheels by following the on-screen indicator until "STOP" is displayed;
• Set the graduated scale necessary for measuring maximum steering to zero on both
turntables.
• lock all the targets, perfectly level
• turn the wheels 10° or 20° to the left until the "STOP" message is displayed;
• wait for the data acquisition;
• turn the wheel further to the left until the steering wheel locks;
• read the graduated scale on the turntables, the internal (left wheel) and external (right wheel)
maximum steering angle and enter the read values in the corresponding fields on the
relevant data input window.
• turn the wheels 10° or 20° to the right (relative to the centre position) until the "STOP"
message is displayed;
• wait for the data acquisition;
• turn the wheels further to the right until the steering wheel locks;
• read the graduated scale on the turntables, the internal (right wheel) and external (left wheel)
maximum steering angle and enter the read values in the corresponding fields on the
relevant data input window.
• turn the wheels back to the left to straighten the steering.
The full steering procedure implies the use of turntables with graduated scale, of suitable sizes.
At the end of the steering procedure, a screen is displayed, with icons indicating the operations
to be performed next:
Position the steering wheel with the spokes straight
Lock the steering wheel
Press F3 (Enter) to confirm and advance to the next screen.
At this point the system acquires and saves the "diagnosis" data for the vehicle, i.e. the values
describing the state of the vehicle prior to adjustment.
These values are then shown on the screen of the measurement data summary table.
33