Preparing The Device - Storch SL 1500 Mode D'emploi

Preparing the device

1.
Assemble the STORCH
airless hose onto the
sprayer. The hose must be
designed for a maximum
working pressure of 230
bar. Screw it firmly and
tightly in place.
5.
Check inlet strainer for
clogs and debris.
9.
Turn the suction valve to
the DRAIN position (verti-
cal).
2.
Connect other end of hose
to gun.
6.
Fill the packing nut with
piston oil to prevent pre-
mature wear of the seal.
Repeat this process for
each spraying procedure.
Paint
flushing
10.
Place the suction system
in an earthed metal contai-
ner that is half-filled with
flushing fluid. Attach an
earthing wire to the con-
3.
Screw firmly and tightly in
place.
7.
Make sure the device is
switched off (OFF).
tainer and a good earthing
point. Run through steps
1 - 5 of the commissio-
ning procedure to flush any
bearing oil out of the sys-
136
4.
Remove the nozzle guard.
8.
Plug the mains cable into
a properly earthed electri-
cal outlet.
tem. Use water to flush
out water-based paint and
white spirit to flush out oil-
based paint and bearing
oil.