Storch SL 1500 Mode D'emploi page 148

3. Insert and tighten the two screws (13). Mount the motor control board (69) using the screws (39).
4. Connect the motor connections and fit into the panel.
5. Connect the display (88) to the motor control board (69).
6. Connect the motor control board power connections.
7. Install the control housing (61) with top two screws (39).
8. Connect the electrical connections and the mains cable connections to the ON/OFF switch (33).
9. Connect the potentiometer connection to the motor control board.
10. Install the control PCB (79) with the screws (72).
11. Connect the display connection to the motor control board (69).
12. Mount the cover (96) using four screws (38).
13. Install the motor cover.
a. Loosen (but do not remove) the four nuts on the shelf and slide the shelf forwards.
b. Refit the cover.
c. Slide the shelf back in position and tighten the four nuts on the shelf.
d. Insert the lower screw of the toolbox and tighten.
e. Reassemble the pressure tube of the sprayer.
f. Re-insert the screws of the motor cover.
148