Query Flow Rate (Dts); Changing The Units; Operation Main Menu - Storch SL 1500 Mode D'emploi

Query flow rate (DTS)

1.
Short press to move to
next display. Press and
hold to change units or
reset data.

Changing the units

1.
Press and hold the DTS
button for 10 seconds to
change the pressure unit
used (psi, bar, MPa). The
selection of bar or MPa
changes gallons to litres x
10. To change the display
units, DTS must be in the
pressure display mode and
pressure must be less than
14 bar.
2.
Set the pressure to its
lowest setting. Trigger
the spray gun to relieve
pressure. Turn the suction
valve to the drain position
(vertical).
2.
Press the DTS button
briefly to change to "JOB
Gallons" (gallons/litres
x 10 per job). Note: JOB
appears briefly in the dis-
play, then the volume
processed at a pressure of
over 70 bar is displayed in
number of gallons/litres x
10.
3.
Switch the device ON. The
pressure display appears.
Dashes will appear if pres-
sure is less than 14 bar.

Operation main menu

1.
Press and hold the DTS
button to reset to zero, or
press it briefly to change
to "Lifetime Gallons" (total
volume gallons/litres x 10).
Note: LIFE appears briefly
in the display, then the
volume processed at a
pressure of over 70 bar
is displayed in number of
gallons.
139
2.
Press the DTS button
briefly to return to the
pressure display.