Basic Settings (End Limits And Angular Travel) - SOMFY J4 io Notice Installateur Et Utilisateur

6.5. Basic settings
6.5.1. Setting upper and lower end limits
Check that your J4 io actuator has been assembled in
the blind in the lowered position with the slats closed.
• Press the Up button for 3 seconds. The blind rotates in the
up direction.
• Stop the blind using the stop on the «mushroom» button. The
end limits are set. The upper end limit is stored on the
mushroom.
6.5.2. Modifying the angular travel
For optimum operation of the J4 io actuator, it is
essential to adjust the angular travel.
The angular travel is the total angle necessary for the
blind to change from a slats closed position to a slats
fully open position.
The slats fully open position is reached when the slats no
longer tilt and the blind makes an initial raising movement.
• Press the down button until the lowered position is reached.
• When the blind is in the lowered position, press the Up and
Down buttons for 5 seconds: the blind moves briefly.
• Press the «my» button on the control point: the blind moves
briefly.
• Move the slats from the slats closed position to the slats fully
open position by briefly pressing the Up button on the control
point.
• Press the Up button and «my» buttons on the control point at
the same time, until the blind moves.
•
© 2014-2016 Somfy SAS. All rights reserved.
or
or
75