Commissioning; Checking The Direction Of Rotation; Setting The End Limits - SOMFY SCREEN UP Notice

EN

2. 3. COMMISSIONING

2. 3. 1. Checking the direction of rotation

Switch the power back on.
1)
Press the button on the control point:
2)
If the motorised product rises (a), the direction of
a)
rotation is correct: Move onto the section entitled

"Setting the end limits".

If the motorised product lowers (b), the direction of
b)
rotation is incorrect: Move onto the next step.
Switch off the power supply.
3)
Reverse the 2 phase wires on the control point.
4)
Switch the power back on.
5)
Press the button.
6)
2. 3. 2. Setting the end limits
The end limits can be set in any sequence.
Setting the upper end limit
Press the button on the control point to raise the
motorised product to the upper end limit and turn the
corresponding setting screw to set the required upper
end limit.
Setting the lower end limit
Press the V button on the control point to lower the
motorised product to the lower end limit and turn the
corresponding setting screw to set the required lower end
limit.
24 Images not contractually binding
1)
3)
5)
Copyright © 2007-2014 Somfy SAS. All rights reserved.
2)
a
=
b
=
4)
6)