Setting The End Limits - SOMFY ALTUS RS 50 io Notice

ALTUS RS 50 io - ALTUS RS 60 io
2. 3. 2. Pre-programming of the Somfy io-homecontrol® local control point
Press the "Up" and "Down" buttons simultaneously:
The motorised product moves up and down.
The control point is pre-programmed in the drive.
Pre-programming is lost if the drive power supply is
switched o before a control point is programmed
completely.
2. 3. 3. Checking the rotational direction:
- Press the "Up" button:
1)
If the motorised product is raised, the direction of rotation
is correct.
If the motorised product is lowered, the direction of rotation
is incorrect. Press the "my" button until the motorised
product moves up and down: the rotational direction has
been modified.
Press the "Up" button to check the rotational direction.
2)

2. 3. 4. Setting the end limits

Pressing and holding the "Up" or "Down" button for more then 2 seconds results in the motorised
product moving up or down continuously.
Position the motorised product at the mid-height position.
1)
Press the "Up" button: The motorised product is moving
2)
upwards.
Press the "my" button to stop the motorised product at the
3)
upper travel end stop position (if necessary, use the "up"
or "Down" buttons to adjust the position of the motorised
product).
Press the "my" and "Down" buttons simultaneously: The
4)
motorised product is moving downwards. The upper travel
end stop is set.
Press the "my" button to stop the motorised product at the
5)
lower travel end stop position (if necessary, use the "up"
or "Down" buttons to adjust the position of the motorised
product).
Press the "my" and "Up" buttons simultaneously: the
6)
motorised product moves upwards. The lower travel end
stop is set.
Press the "my" button to stop the motorised product.
7)
Press the "my" button until the motorised product moves up and down to confirm the travel end stop
8)
settings.
Copyright 2017 SOMFY ACTIVITES SA, Société Anonime All rights reserved.
©
0.5
S
1)
The direction of
rotation is correct
2)
1) 2)
3) 4)
5) 6)
7) 8)
EN
37