Safety; Safety And Responsibility; Specific Safety Advice - SOMFY J4 io Notice Installateur Et Utilisateur

2. SAFETY

2.1. Safety and responsibility

- The motor, torque and operating time must be adjusted according to the complete installation.
- Only Somfy original accessories should be used (adapters, brackets, connectors, power cable, etc.).
- Fitting, testing, commissioning and repair of the installation must only be carried out by qualified personnel.
- The installer must also comply with the current standards and legislation in the country in which the product
is being installed, and inform his customers of the usage and maintenance conditions relevant to the product.
- The moving parts of the motors must be protected if operating at less than 2.50 m from the ground or
another surface.
- The installation must not be used if it shows any signs of damage (for example wear, damaged cables and
springs or ill adjusted end limits).
- The installation must be protected from all unauthorised use. Take preventive measures to avoid any
spurious operation.
- Children must be supervised to ensure they do not play with the equipment. Keep remote controls out of
the reach of children.
- This equipment is not intended for use by persons (including children) with impaired physical or mental
capacities or those without the required knowledge or experience unless supervised by a person responsible
for their safety.
- Disconnect all the connection cables from the power supply before operating on the installation.
- Do not use the installation if operations (window cleaning for example) are being carried out nearby.
- Observe the assembly and use guidelines, in particular the safety instructions from the manufacturer of the
device to be used , since incorrect installation can lead to severe injury.
- Permanently mounted controls must be mounted visibly.
- The power supply cables of the motor must only be replaced by a cable of the same type, delivered by the
manufacturer of the motor.
- If the mushroom is used to stop the blind in the upper end limit position, the installer must check that the
mushroom is in place when the complete installation is used for the first time.
- To remove the motor power cable: Please use the «J4 cable dismantling tool» ref: 9017811
Subject to technical modifications.

2.2. Specific safety advice

1)
Switch off the mains supply for the external venetian blind
before performing any service operation in the vicinity.
To avoid damaging the product:
2)
Never immerse it in liquid!
3) Avoid impacts!
4)
Do not drop it!
5)
Never drill holes in it!
6)
Avoid moving the blind if ice has formed on it.
© 2014-2016 Somfy SAS. All rights reserved.
1 2
OFF
3 4
5 6
65