Adding/Deleting Somfy Io Control Points And Io Sensors; Modifying The End Limits - SOMFY J4 io Notice Installateur Et Utilisateur

8.2. Adding/Deleting Somfy io control points and io sensors

Refer to the corresponding guide.

8.3. Modifying the end limits

8.3.1. Modifying the upper end limit
• Place the blind in the intermediate position.
• Press the Up and Down buttons for 5 seconds the blind
moves briefly.
• Press the Up button (The blind rotates, stops, then continues
to turn in the up direction) until the required end of travel is
reached (The blind will continue to rise after the control point is
pressed for 3 seconds).
• Stop the blind in the required position (If the end of travel has
been set on the mushroom, the effective end of travel will be
stored slightly below the mushroom).
• Press the Down button.
The blind will move briefly to confirm storage.
Note: If a new end of travel needs to be set beyond the exis-
ting end of travel, the blind will stop itself at the existing
end of travel. It will be necessary to press the control point
again to go past this existing end of travel.
8.3.2. Modifying the lower end limit
• Place the blind in the intermediate position.
• Press the Up and Down buttons for 5 seconds the blind
moves briefly.
• Press the Down button (the blind will turn, stop, then continue
in the down direction) until the required lower end of travel is
reached (the blind will continue to lower when the control point
is pressed for 3 seconds).
• Stop the blind in the required position.
• Press the Up button.
The blind will move briefly to confirm storage.
Note: If a new end of travel needs to be set beyond the exis-
ting end of travel, the blind will stop itself at the existing
end of travel. It will be necessary to press the control point
again to go past this existing end of travel.
78
© 2014-2016 Somfy SAS. All rights reserved.