Checking The Direction Of Rotation; Setting The End Limits - SOMFY Oximo 40 io Notice

2.3. COMMISSIONING
2.3.1. Pre-programming the control point
1) Switch on the power supply.
2) Press the Up and Down buttons on the control point at the
same time: The motorised product moves up and down (fast
raising and lowering), and the control point is pre-programmed
in the motor.
The motorisation is in programming mode for ≈ 10 min.

2.3.2. Checking the direction of rotation

1) Press the Up button on the control point:
a) If the motorised product rises (a), the direction of
rotation is correct: Move onto the section entitled "Setting
the end limits".
b) If the motorised product lowers (b), the direction of
rotation is incorrect: Move onto the next step.
2) Press the my button on the control point until the motorised
product moves up and down: The direction of rotation has
been modified.
3) Press the my button until the motorised product moves up
and down.

2.3.3. Setting the end limits

Setting the end limits in automatic mode (2.3.3.a)
1) Press the Up and Down buttons on the control point at the
same time: The motorised product moves up and down (fast
raising and lowering).
2) Press the my button until the motorised product moves up
and down.
Setting the end limits in manual mode (2.3.3.b)
The end limits can be set in any order.
1) Raise the motorised product to the desired position by
pressing the Up button.
2) Press the my and Down buttons at the same time until the
motorised product moves.
The upper end limit is memorised.
3) Press the my button when the motorised product reaches
the desired lowered position. If necessary, adjust the position
of the motorised product using the Up and Down buttons.
4) Press the my and Up buttons at the same time until the
motorised product moves.
The lower end limit is memorised. The motorised product
rises and stops in the raised position.
5) To confirm the end limits, press the my button until the
motorised product moves up and down.
The end limits are programmed.
Copyright © 2016 Somfy SAS. All rights reserved.
1
ON
1
a
b
2
1
1
3
5
Images not contractually binding
EN
2
Setting the
end limits
Move onto
the next step
3
2
2
4
5