Tips And Recommendations; Questions On The J4 Io - SOMFY J4 io Notice Installateur Et Utilisateur

9. TIPS AND RECOMMENDATIONS

9.1. Questions on the J4 io?

Observations
The wiring is incorrect.
The blind does not
operate.
The motor is hot.
The Somfy io control point battery
is low.
The control point is not compatible.
The Somfy io control point used
has not been programmed into the
actuator.
The blind stops too
The end limits have been incorrectly
soon or too late.
set.
Despite the presence
The sensor is not paired/set.
of a sunlight sensor,
when the sunlight is
The sensor is paired/set.
low the blind does
not tilt the slats to the
horizontal position.
The «my» position is cleared.
I can't tilt the slats
The remote control is not compatible.
easily.
I can't tilt the slats
properly.
The angular travel is incorrectly set.
The»my» position is
The «my» position is cleared.
not working.
My «my» position
The angular travel is incorrectly set.
cannot be repeated.
There is excessive play in the blind
ladders or mechanics.
The blind (or one of
several) does not
Pairing or setting has been not
react as described
executed correctly.
in the manual during
pairing or setting.
I have a wind sensor
and the blind rises to
The sensor is paired/set.
the upper end limit
regularly or even
The battery of the Somfy io sunlight
every hour
sensor is weak.
Despite the presence
of a wind sensor,
when it is windy, the
The sensor is not paired/set.
blind does not reach
the upper position.
I don't think the There is excessive play in the blind
position between the ladders or mechanics.
end limits is accurate.
80
Possible causes
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or program
this control point.
Readjust the end limits.
Read the sensor manual to carry out the
pairing and appropriate settings
Readjust the angular travel.
Set the «my» position.
Pairing and using a Situo mobile io VB/
Easy Sun io/Composio io/Smoove io remote
control.
Readjust the angular travel.
Set the «my» position.
Re-régler la course angulaire puis Re-régler
la position favorite «my».
No solution by adjusting the J4 io. Recall the
«my» position from the lower end limit.
Only cut shortly the power and repeat the
procedure if necessary.
There is radio interference or the sensor is
out of reach. Position the EVB - Slim receiver
for Variation io outside the head rail.
Check whether the battery is weak and
replace it if necessary.
Refer to the corresponding guide to pair/set
the sensor.
No solution by adjusting the J4 io. Recall the
«my» position from the lower end limit.
© 2014-2016 Somfy SAS. All rights reserved.
Solutions