Programming The First Somfy Io Local Control Point; Checking The Settings; Standard Operation; Operating With A Somfy Sensor Or Automatic Function - SOMFY J4 io Notice Installateur Et Utilisateur

6.6. Programming the first Somfy io local control point

6.6.1. Using a pre-programmed Somfy io local control point (6.2)
Briefly press the PROG button on this control point: the blind
moves briefly, the control point has been programmed.
6.6.2. After a power cut
• Press the Up and Down buttons on the new control point
simultaneously until the blind moves.
• Briefly press the PROG button on this control point: the blind
moves briefly; the control point has been programmed.

6.7. Checking the settings

Check the settings of the upper and lower end limits using the Somfy io local control point.
7. OPERATING

7.1. Standard operation

points: Situo mobile io VB, Easy Sun io, Composio io and Smoove io)
7.1.1. Favourite position (my)
Besides the upper and lower positions, an intermediate position known as the «favourite position
(my)» may be programmed in the motor. The "my" favourite position is pre-set in the factory, and
corresponds to the "slats lowered, sun protection" position.
To modify or delete the favourite position (my), see the section entitled «Modifying settings».
To use the favourite (my) position: Briefly press the «my»
button: the blind starts to move, then stops and angles the slats
in accordance with the angle programmed for the favourite (my)
position.
7.1.2. STOP function
The blind is moving.
Briefly press the «my» button: the blind stops automatically.
7.1.3. Up and Down buttons
A brief press on the Up or Down buttons causes the slats of
the blind to turn.
A long press on the Up or Down buttons will cause the blind to
raise or lower completely.

7.2. Operating with a Somfy sensor or automatic function

Refer to the corresponding manual for the Somfy io sensor.
76
(the operation below is only possible with the following control
© 2014-2016 Somfy SAS. All rights reserved.