Operation For E.v.b. With A Kinematic Working Position And The Use Of A Remote Impresario Chronis Io; Favourite Position (My) - SOMFY J4 io Notice Installateur Et Utilisateur

7.3. Operation for E.V.B. with a kinematic working position and the use of a remote
Impresario Chronis io
If you use an Impresario Chronis io remote control with a blind that has
operating position kinematics, only the following scenarios work:
- Upper end limit position (A)
- Lower end limit position (B)
- All slat angles, provided that the blind is in the lower end limit
position (C)
The scenarios for setting a mid-position between the upper
and lower end limit positions are not possible with the J4 io
actuator.
8. MODIFICATION OF THE SETTINGS

8.1. Favourite position (my)

8.1.1. Modifying the favourite position (my)
• Place the blind in the required new favourite position (my).
• Press the «my» button until the blind moves: the new favou-
rite position (my) has been programmed.
8.1.2. Programming favourite (my) positions for products
with multiple operating positions
If the blind has operating position kinematics, the favourite (my)
position must ONLY be programmed in the lower end limit posi-
tion with the slats set at an angle along the angular travel
• Ensure the blind is in the lower end limit position with the slats
closed.
• Incline the slats to obtain the desired angle or the angle
corresponding to the operating position angle.
• Press the (my) button until the blind moves: The new favourite
position (my) has been programmed.
8.1.3. Deleting the favourite (my) position
• Press the «my» button: the blind will start to move and will
stop in the favourite position (my).
• Press the «my» button again until the blind moves: the
favourite position (my) has been deleted.
© 2014-2016 Somfy SAS. All rights reserved.
A
B
C
77