Pre-Programming The Somfy Io Local Control Point; Checking The Motor's Direction Of Rotation; Choice Of Kinematics (Normal Or With Working Position) - SOMFY J4 io Notice Installateur Et Utilisateur

c) The blind still does not move
The end limits are not set and no
Somfy control point has been stored.
Go to the section entitled 6.2 «Pre-programming the
Somfy io local control point».
or
d) The blind is fully raised or lowered
The end limits are set and the
Somfy control point has been stored.
Go to the section entitled «Operation».

6.2. Pre-programming the Somfy io local control point

• Press the Up and Down buttons simultaneously.
The blind moves briefly, the Somfy local io control point is pre-
programmed to the motor.
6.3. Checking the motor's direction of rotatio
• Press the Up button:
a) If the blind raises, the direction of rotation is correct:
go to the section entitled 6.4 «Basic Settings».
b) If the blind lowers, the direction of rotation is incorrect:
press the «my» button until the blind moves, the direction of
rotation is modified.
• Press the Up button to check the direction of rotation

6.4. Choice of kinematics (Normal or with working position)

The J4 io actuator is factory set to operate with a blind with normal kinematics. However, the user can choose
between blind operation modes, either with normal kinematics or kinematics with working position.
• Press the Up and «my» buttons to switch between operating modes.
If the motor switches from normal kinematics mode to kinematics with wor-
king position mode, the blind moves briefly at slow speed.
If the motor switches from kinematics with working position mode to normal
kinematics mode, the blind moves briefly at normal speed.
If the J4 io is being used with a TaHoma application, this parameter
setting MUST be adhered to in order to attain the appropriate TaHo-
ma visual module.
74
a
=
b
=
© 2014-2016 Somfy SAS. All rights reserved.
Pre-programming the
Somfy io local control
point
Operation
Setting the end limits