Free-Wheel Function; Battery Care - Numatic CRO 8055/100T Notice Originale

!
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
The CRO 8055 is equipped with a free-wheel function that will enable the operator to move the machine.
The Free-wheel lever can be found on the right hand side of the rear axle (Fig.59).
To disengage the brake, pull the lever into the down position (Fig.60).
Re-engage the brake by moving the lever into the up position.
!
When the brake is disengaged the machine is in Free-wheel mode and has no braking
facility. Care must be taken when moving the machine in Free-wheel mode.
To ensure your machine remains at its maximum efficiency and prolong your battery life, please follow the
simple steps below:

Free-wheel Function

ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND
BEFORE DISENGAGING BRAKE ARM.
59
Under normal daily usage:
Recharge batteries after each use regardless of machine operation time.
Recharge the machine fully after its last use.
Do not leave the machine in a discharged state.
60

Battery Care

42
!
!