Free-Wheel Function - Numatic CRG 8055/100T Notice Originale

Machine Cleaning
!
Always ensure that the machine is switched off prior to any maintenance.
Located in your waste water top tank is a vacuum shut off system, this prevents suction when the waste water tank is full. It also
prevents foam created by high-foaming detergents from entering the motor. Sometimes the float vents get clogged and blocked,
clean to ensure correct operation. Reguarlly check and clean the air filter in the top of the assembly. Remove debris basket filter and
rinse using clean water, and refit.
IMPORTANT: If the debris basket is allowed to become clogged, vacuum performance can deteriorate.
Float vent.
The clean water tank filter is located to the front of the battery compartment, and should be checked at regular intervals.
Lift the filter off of the cradle, unscrew the bottom and remove, taking care not to spill any liquid on to the batteries.
Rinse using clean water and refit, refitting is reversal of removal.
NOTE: Any Spills should be wiped up before tank is lowered.
Free Wheel Function
!
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
The CRG 8055 / 8072 is equipped with a free wheel function that will enable the operator
to move the machine.
The free wheel lever can be found on the right hand side of the rear axle.
To disengage the brake, pull the lever into the down position.
Re-engage the brake by moving the lever into the up position.
NOTE: When the brake is disengaged the machine has no braking facility.
Care must be taken when moving the machine in free wheel mode.
24
www.numatic.co.uk
Air filter.
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND
BEFORE DISENGAGING BRAKE ARM.
Debris basket removal.
Machine shown on it's side.
!
!