Motor Brake Disengage Lever / Towing; Free-Wheel Function - Numatic Nacecare TTB 3226 Mode D'emploi

!
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE
NEVER TOW THE MACHINE WITH THE BRAKE ENGAGED.
The TRO 650 is equipped with a free-wheel function that will enable the operator to move / tow the machine.
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL
GROUND BEFORE DISENGAGING BRAKE ARM.
IS ON A SLOPE / GRADIENT.
The motor brake is disengaged by opening the
brake arm on the side of the drive wheel (see Fig.40).
Fig.40
Your start-up kit includes a brake drive disengage key (329945, see Fig.41)
which can be inserted between the brake arm and drive housing
(see Fig.42).
Fig.41
Once the key has been inserted (see Fig.42)
the motor brake will be fully disengaged.
The machine will now be in full free-wheel mode.
Fig.42
When towing the machine ensure that a suitable tow bar is used.
Care must be taken when towing; maximum speed to be no more than 7kmh.
The machine can be towed from the front bar as indicated (see Fig.43).
WARNING!
WHEN THE BRAKE IS DISENGAGED THE MACHINE IS IN FREE-WHEEL
MODE AND HAS NO BRAKE FACILITY, THEREFORE A RIGID TOW BAR
MUST BE USED IF TOWING.
Fig.43
Remember to remove the brake disengage key when you reach your
final destination / before using the machine.
20

Free-Wheel Function

!