Free-Wheel Function - Numatic TTB 6055/100T Mode D'emploi

!
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE DISENGAGING BRAKE
ARM. NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
The TTB 6055T is equipped with a free-wheel function that will enable the operator to move the machine manually
if required.
45
46
47
!
WHEN THE BRAKE IS DISENGAGED THE MACHINE IS IN FREE-WHEEL MODE
Note: None of the other functions on the machine will work whilst in the free-wheel mode.
Remember to re-engage the drive when you reach your final destination / before using the

Free-wheel Function

The motor brake is located on the left side of the machine near the rear
wheel (see Fig.45).
Pull the arm out (see Fig.46).
Swing to the disengaged position (see Fig.47).
The motor brake will be fully disengaged.
The machine will now be in full free-wheel mode.
WARNING!
AND HAS NO BRAKE FACILITY.
46
!
!
machine..