Machine Operation; Setting The Cleaning Controls; Waste Water Tank Full - Numatic CRO 8055/100T Notice Originale

!
Do not operate machine unless the operator manual has been read and fully understood.
The machine is now ready to be driven to the cleaning site (see the quick set-up guide if necessary).
Before performing the cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor.
When you have arrived at the cleaning site, lower the Floor-tool (see page 8) and the brush deck (see page 9).

Setting the Cleaning Controls

26
Waste-water Tank Full
!
Always ensure that the floor is pre-swept and relevant safety signs are displayed.

Machine Operation

IMPORTANT
27
The vac shut off system fitted to your machine stops the
airflow when the top tank is full!
It does not shut the power off to the vac motor, the vac
motor will continue to run, but there is an audible difference
in the sound when the shut off system operates.
See Page 16 for more details on checking and cleaning
the shut off system.
Insert the key into the on / off switch and quarter-turn it
clockwise to the 'ON' (1) position (Fig.26).
The battery charge-level indicator will illuminate (Fig.27).
Set the water flow rate as required, depending on floor
type and level of soiling.
= No Flow
= 0.5 L/min
= 1.0 L/min
= 1.5 L/min
= 2.0 L/min
= 3.0 L/min
24
!
!