Quick Set-Up Guide - Numatic CRO 8055/100T Notice Originale

Table des Matières

Publicité

!
AFTER THE REMOVAL OF ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
2
Lift top tank assembly to reveal battery compartment.
Always lift between points as illustrated to ensure personal safety (Fig.1).
Fit battery fuse into the battery fuse holder as illustrated (Fig.2).
Remove transit block from pallet (Fig.3).
!
Ensure no metal objects come into contact with battery terminals while the batteries are
exposed. When inserting the fuse you may notice a spark, this is normal.
4
Insert key into ignition and turn quarter-turn clockwise to the 'ON' (1) position, make sure that the forward / reverse switch
is set to forward and the speed control is set to low (Fig.4).
DO NOT depress accelerator pedal while software initialises.
Depress accelerator pedal with right foot and slowly drive machine off of the pallet using the ramp provided (Fig.5).
Make sure the ramp is central to the machine and drive off straight.
Note: The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
When the machine is removed and in a safe position, turn key back to the 'OFF' (0) position (Fig.6).

Quick Set-Up Guide

PLEASE READ BEFORE COMMENCING ANY OPERATION
Contents:
1 x Operator Manual
2 x Battery Charger Lead
2 x Keys
1 x 40 Amp Fuse (1 x Spare)
1 x Maxi Fuse-puller
5
1
3
16
6
!
!

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cro 8055/120t

Table des Matières