Free Wheel And Towing - Numatic TRG 720/200T Notice Originale

!
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE
DISENGAGING BRAKE ARM. NEVER DISENGAGE THE BRAKE WHEN
THE MACHINE IS ON A SLOPE / GRADIENT. NEVER TOW THE MACHINE WITH THE
BRAKE ENGAGED AND POWER PLUG CONNECTED! REMOVE BATTERY FUSES
1
The TRG 720 / 200T and TRG 720 / 300T is equipped with a
free wheel function that will enable the operator to move / tow
the machine. The motor brake is disengaged by opening the
brake arm on the side of the drive wheel (see Fig.1).
3
Once the key has been inserted (see Fig.3)
the motor brake will be fully disengaged.
The machine will now be in full free wheel mode.
5
Pull the power connector block apart and refit the two
retaining knobs. When destination place reached, remove
brake disengage key, connect power plug, fit fuses.
WHEN THE BRAKE IS DISENGAGED AND POWER PLUG IS DISCONNECTED THE MACHINE IS IN
!
FREE WHEEL MODE AND HAS NO BRAKE FACILITY, WHEN TOWING THE MACHINE
Remember to remove the brake disengage key when you reach your final destination / before using the machine.
NOT FOLLOWING DESCRIBED METHOD COULD DAMAGE MAIN CONTROL UNIT AND VOID THE WARRANTY.
WARNING!
ENSURE THAT A SUITABLE TOW BAR IS USED.

Free wheel and towing

2
Your start-up kit includes a brake drive disengage key
(329945, see Fig.2) which can be inserted between the brake
arm and drive housing (see Fig.3).
4
A
Undo and remove the two retaining knobs (fig.A&B).
Remove battery fuses.
6
When towing the machine ensure that a suitable tow bar is
used. Care must be taken when towing; WHEN TOWING DO
NOT EXCEED AVERAGE SPEED OF 3 KPH. The machine can
be towed from the front bar as indicated (see Fig.6).
!
B
!
T (+ 44) 01460 68600
27