Table des Matières
Publicité
Machine Operation
C
Free Wheel Function
1
The TGB 6055/100T is equipped with a free-wheel function that will enable the operator to move the machine manually if required.
The motor brake is located on the right side of the machine near the rear wheel.
Pull the arm out (Fig.1). Swing to the disengaged position (Fig.2).
The motor brake will be fully disengaged. The machine will now be in full free wheel mode.
!
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE DISENGAGING BRAKE ARM.
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
Note: None of the other functions on the machine will work whilst in the free-wheel mode.
Remember to re-engage the drive when you reach your final destination / before using the
Setting the Cleaning Controls
B
Insert the key, turn the main control on / off key to position '1'.
(Fig.A) The battery charge-level indicator will illuminate for 5
seconds.
Set desired traction speed as required, depending on floor type
A
and level of soiling (Fig.B).
Middle speed is the optimum cleaning speed.
The TGB 6055/100T is equipped with an electronic braking
system.
Simply release the hand operated start / stop trigger and the
machine will stop.
In an emergency, strike the Emergency Stop button. (Fig.C).
The machine will be disabled.
To reset, turn Emergency Stop button clockwise.
After re-setting the Emergency Stop button, to restart the
machine, turn the main control on / off key to '0' and then
position '1'.
2
!
machine..
29
T 01460 68600
Publicité
Table des Matières
