Machine Operation; Lowering The Floor Tool - Numatic TTB-1620/100T Mode D'emploi

!
When handling and mixing chemicals.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-driers.
Note: The top (waste) tank is fitted with a pressure sensor that disables the machine until the top tank is closed.
Note: always ensure that the waste-water tank is empty before lifting.
!
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place-out appropriate warning signs and sweep or dust-mop the floor

Lowering the floor tool

Fig.19
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered (Fig 19).
Move the Floor tool lever, to it's lower position (Fig 20).
Note: The machine will still reverse with the Floor tool in the lowered position, this could possibly damage the
blades. Raise the floor tool before selecting reverse.

Machine Operation

21
Fig.20
!
!