Table des Matières
Publicité
18
Pre-scrub mode
The TT Range have been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work, then scrub the area a
second time with the floor-tool lowered.
Floor-tool in use
19
Lowering the floor-tool
21
Note: The machine will still reverse with the floor-tool in the lowered position,
this could possibly damage the blades. Raise the floor-tool before reversing.
Machine Operation
!
The clean-water / chemical mix is
dispersed via the 'THRU-FEED'
system.
The waste water is then retrieved by
the floor-tool.
Overlap the scrubbing path by 10cm
to ensure an even clean (Fig.19).
If streaking occurs, wipe the
floor-tool blades clean (Fig.20).
After preparing the floor (see
previous section), we are now
ready to set the controls to suit the
cleaning conditions.
Before any settings can be applied,
ensure the brush deck is lowered.
Move the Floor-tool lever (see
Fig.21), to it's lower position (see
Fig.22).
24
Pre-cleaning advice
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the
floor (Fig.18).
Numatic part (629044) Wet Floor sign
(available if required)
ALWAYS ENSURE THAT THE FLOOR IS
PRE-SWEPT AND RELEVANT
SAFETY SIGNS ARE DISPLAYED.
20
22
!
Publicité
Table des Matières
