Pre-Scrub Mode; Machine Operation; Floor Tool In Use - Numatic TT 516 Mode D'emploi

Pre-scrub mode

The TT 516 has been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position (Fig 21), allow the chemical time to work, then scrub
the area a second time with the floor-tool lowered.
To raise the floor-tool, ensure the floor-tool carrier is central to the machine (Fig 22).
Lift the lever near the base of the handle and lock into position (Fig 23).
Note The lever moves upward and backward motion to lock the floortool in the raised position.

Floor tool in use

If streaking occurs, wipe the floor-tool blades clean (Fig 25).
Note
Care must be taken to reduce speed when cornering or when manoeuvring around obstacles.
Fig 21
The clean-water / chemical mix is deposited via 'THRU-FEED' system.
The waste water is then retrieved by the floor-tool
Overlap the scrubbing path by 10cm to ensure an even clean (Fig 24).
Fig 24
Fig 22 Fig 23
Fig 25
8

Machine Operation